Configuring Gateway Endpoints On The Nrs - Nortel NN49000-315 Integration Manual

46 NRS configuration
Figure 8
NRS configuration task flow
Task flow navigation
•
•
•
Configuring gateway endpoints on the NRS
Perform the following procedure to configure the MCG gateway endpoints
on the Network Routing Service (NRS). You must perform this procedure
for each MCG node on the system.
On NRS redundant systems, perform all configuration on the primary NRS.
Procedure steps
Step
1
2
3
4
Mobile Communication 3100 and Communication Server 1000 Solution Integration Guide
.
"Configuring gateway endpoints on the NRS" (page 46)
"Adding an NRS Routing rule" (page 47)
"Adding a User Endpoint" (page 49)
Action
Open NRS Manager by doing one of the following:
In Element Manager, select Dialing and Numbering Plans,
Network Routing Service.
OR
In Internet Explorer, enter the IP address of the NRS into the
address bar.
Select the Configuration tab.
Click set Standby DB view to switch from active to standby
database view.
Click Gateway Endpoints.
Nortel Mobile Communication 3100
NN49000-315 02.01
Copyright © 2008-2009 Nortel Networks. All Rights Reserved.
2 October 2009