Configuring The Equipment - Nortel Communication Server 1000 Series Manual

2
Connecting the power source at the remote site
To install the DC power source to the Fiber Remote Multi-IPE Interface
unit at the remote site, refer to
71). To install and connect the Power Converter to the Fiber Remote
Multi-IPE Interface unit at the remote site, refer to
Power Converter" (page
Configuring the equipment
Theconfiguration and administration of Remote IPE at one or more remote
sites and at the local site are identical to the standard system configuration
and administration and do not require special considerations.
However, there are some Fiber Remote Multi-IPE Interface initial setup
functions that must be considered at either local or the remote site. These
functions are administered over aman machine interface (MMI) port
connected to a terminal at the local and the remote sites.
When configuring Remote IPE functions at the local and the remote
sites you can configure the Superloop Network cards and the Peripheral
Controller cards dedicated to the Remote IPE exactly the same way any
other standard Superloop Network cards and Peripheral Controller cards
are configured by using:
•
•
Factory default parameter settings
The Fiber Remote Multi-IPE Interface units are set in the factory as listed
in Table 15 "Factory default parameter settings" (page
Table 15
Factory default parameter settings
Parameter
Time
Date
Copyright © 2007-2009 Nortel Networks
.
Connect the other end of the cable open wires to two external
alarm input devices and one external alarm output device.
Observe the wire color codes and their corresponding pin
assignments at the DB-9 connector to correctly connect alarm
devices to the Fiber Remote Multi-IPE Interface unit.
Configuration Record programs LD 17 and LD 97
MMI commands to configure the Fiber Remote Multi-IPE Interface
parameters
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
--End--
"Connecting the DC power source" (page
73).

Configuring the equipment 89

"Connecting the AC/DC
89):
Default setting
Central Standard Time
Current