Reading Service Data - Siemens SIMATIC ET 200iSP Operating Instructions Manual

• The files with the current (new) firmware version are available in the file system of your PG/
PC.
• You have selected the header.upd file.
Updating firmware via network connection
For information on the procedure, see the STEP 7 online help.
Restarting following an update
The following setting options are available via the "Update firmware after download" parameter
to restart after updating the interface module:
• "Update firmware after download" enabled:
When the update is completed successfully, a reset of the IM 152-1DP is performed
automatically. The module restarts with the newly loaded firmware.
• "Update firmware after download" disabled:
If the update is completed successfully, the IM 152-1DP continues to run with the firmware
loaded before the update.
The newly loaded firmware is only restarted after the supply voltage is temporarily not
available.
For redundant systems, the "Update firmware after download" parameter cannot be disabled.
Bad update
If the update fails, the IM 152-1DP starts up with the ("old") firmware that was active before the
update after the supply voltage is switched off/on. See table Status and error LEDs on the IM
152-1DP in the section Status and error LEDs on the IM 152-1DP (Page 173).
8.9

Reading service data

Properties
The service data contains special information about the status of an ET 200iSP station for
diagnostic purposes.
If you want to transfer the service data of your system to the customer support in case of service,
you have to consider the following:
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK
CAUTION
STOP of CPU possible
If the "Update firmware after download" field is selected, the ET 200iSP station will be
briefly interrupted. If you have not made any provisions for this situation, the update will
cause to CPU to go to STOP mode due to a rack failure.
Maintenance
8.9 Reading service data
235