Prerequisites - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Commissioning guideline

3.2 Prerequisites

3.2 Prerequisites
Requirements
The following requirements must be met:
• You must be familiar with the basics of electrical and electronic engineering and the
procedures relating to potentially explosive atmospheres and have experience working with
computers and Microsoft® Windows™.
• You have selected a variant of the connection of the ET 200iSP with the CPU:
– Connection via PROFINET IO (interface module IM 152-1PN required)
– Connection via PROFIBUS DP (interface module IM 152-1DP required)
• If you implement this example in a hazardous area, you must adhere to all the rules and
regulations explained and listed in this manual.
Note
During functional checks, you must observe the guidelines according to EN 60079-17. This
standard contains the provisions of international standard IEC 60079-17.
See also
Basics of commissioning and diagnostics (Page 155)
38
DANGER
Observe the installation regulations
When laying cables and wiring in hazardous areas, adhere to the installation regulations in
accordance with EN 60079-14 and any regulations specific to your country.
DANGER
Observe permitted components
When using the IM 152-1PN interface module, observe the Class 1 limits according to IEC
60825-1. Only use approved media converters and fiber-optic cables.
Optical radiation that is high in energy (laser) can be an ignition source.
WARNING
Observe the safety regulations
The ET 200iSP distributed I/O station is subject to special rules and regulations depending
on its application.
Please observe the applicable safety and accident prevention regulations, e.g. IEC 204
(EMERGENCY-STOP devices).
You risk severe injuries or damage to machines and equipment if you ignore these directives.
Operating Instructions, 11/2022, A5E00247483-AK
ET 200iSP