Wiring The Example Configuration For Profinet - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Installing the component
1. Install the mounting rail (160 mm) on a stable base.
2. Place the component from below onto the DIN rail and turn it into place.
Note
Install the component in Zone 2 or in a safe area. Use an enclosure.
3.6

Wiring the example configuration for PROFINET

Wiring of the TM-PS-A
Figure 3-2
Requirements for example configuration with PROFINET IO/fiber-optic cable
• PROFINET IO cable with RJ45 or FastConnect plug at both ends
• Fiber-optic cable with LC plug at both ends
Observe the following information:
– Optical connection in and through ATEX/IECEx Zone 1 or 21
Wiring the example configuration
1. Connect the engineering tool (PG) and the PROFINET IO interface of the CPU using your own
cable.
2. Connect the DIN rails of the CPU with the protective conductor.
3. Connect the mounting rail of the ET 200iSP and the power supply PS with the equipotential
bonding PE. Use the grounding bolt for fastening to the DIN rail.
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK
Wiring TM-PS-A
support.industry.siemens.com/cs/ww/en/view/109761426)
3.6 Wiring the example configuration for PROFINET
Commissioning guideline
(https://
43