Identification And Maintenance Data I&M - Siemens SIMATIC ET 200iSP Operating Instructions Manual

4.10 Identification and maintenance data I&M
Properties
Identification data (I data): Information about the module that is normally printed on the
enclosure of the module. I data is read-only.
Maintenance data (M data): System-specific information such as the installation location and
date. M data is generated during configuration and written to the module.
Identification and maintenance data (I&M) is information stored in a module that supports you
in
• Troubleshooting in a system
• Checking the system configuration
• Locating hardware changes in a system
Reading and writing the identification and maintenance data with STEP 7
• PROFINET connection via IM 152-1PN:
In HW Config, the I&M are displayed in the "Module status - IM 152-1PN" and "Properties -
IM-152-1PN" tabs.
• PROFIBUS connection via IM 152-1DP:
In HW Config, the I&M are displayed in the "Module status - IM 152-1DP" and "Properties - DP
Slave" tabs.
For additional information on this: See STEP 7 online help.
Reading and writing of the I&M with SIMATIC PDM
With SIMATIC PDM you can read the parameters and I&M e.g. via the menu command File > Full
upload to PG/PC and write via the menu command Device > Full download to device .
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK
Configurations (principle)
4.10 Identification and maintenance data I&M
77