Siemens SIMATIC ET 200iSP Operating Instructions Manual page 158

Commissioning and Diagnostics
7.1 Basics of commissioning and diagnostics
Acyclic data exchange via PROFIBUS DP
An acyclic data exchange takes place between the SIMATIC PDM and the PG/PC (ET 200iSP). The
ET 200iSP is configured via acyclic data exchange. In addition, identification and maintenance
data is transmitted and displayed in SIMATIC PDM.
• Diagnostics and interrupts (with S7 DP device and DPV1 device)
• Data records
Software requirements
Table 7-1
Configuration software used
STEP 7
STEP 7 and SIMATIC PDM (SIMAT‐
IC PDM is integrated and availa‐
ble as "stand-alone" version)
PCS 7 (contains, among other
things, STEP 7 and SIMATIC PDM)
PCS neo
TIA Portal
COM PROFIBUS and SIMATIC PDM
(SIMATIC PDM is integrated and
available as "stand-alone" ver‐
sion)
Other configuration software
and SIMATIC PDM (SIMATIC PDM
is integrated and available as
"stand alone" version)
158
Software requirements
Version
PROFINET: STEP 7 as of V5.7 SP1
and current hardware update
PROFIBUS: STEP 7 as of V5.3 SP1
and current hardware update
STEP 7 as of V4.02
PROFINET: SIMATIC PDM as of
V9.2.2
PROFIBUS: SIMATIC PDM as of
V6.0
PROFINET: PCS 7 as of V9.1 SP2
PROFIBUS: PCS 7 as of V6.1
PROFINET: PCS neo as of V4.0
PROFIBUS: PCS neo as of V3.0
PROFINET: TIA Portal as of V18
PROFIBUS: TIA Portal as of V13
COM PROFIBUS as of V5.0
PROFINET: SIMATIC PDM as of
V9.2.2
PROFIBUS: SIMATIC PDM as of
V5.2
Other configuration software
(see manufacturer for version)
PROFINET: SIMATIC PDM as of
V9.2.2
PROFIBUS: SIMATIC PDM as of
V5.2
Explanations
The ET 200iSP is included in the
hardware catalog of HW Config.
You configure and parameterize
the ET 200iSP with HW Config.
You need the GSD file from the
ET 200iSP and configure with HW
config...
... and configure them with SI‐
MATIC PDM.
See documentation for PCS 7
See documentation for PCS neo
See documentation for TIA Portal
You need the GSD file from the
ET 200iSP and configure with
COM PROFIBUS...
... and configure them with SI‐
MATIC PDM.
You need the GSD file from the
ET 200iSP and configure with a
suitable configuration software...
... and configure them with SI‐
MATIC PDM.
Operating Instructions, 11/2022, A5E00247483-AK
ET 200iSP