Digital Electronic Module 4 Do - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Digital electronic modules
13.5 Parameters of the digital electronic modules
13.5.2

Digital electronic module 4 DO

Parameters 4 DO
Table 13-18 Parameters for 4 DO
Parameters: shut Parameters: shut
down "H" modules down "L" modules
Parallel connection of channels
Response to CPU/ master STOP
Substitute value
Group diagnostics
Diagnostics, Wire break
2
Diagnostics: wire break
--- Disable shutdown sig‐
nal
Not possible with 4 DO DC23.1V/20mA.
1
The wire break is detected in the digital output module only with "1" signal.
2
Only possible with SIMATIC PDM and in HW Config with "*" after the article number.
3
Substitute values in Flash memory
The substitute values are stored in the flash memory of the interface module. These are output
at the next startup of the ET 200iSP until the ET 200iSP exchanges data with the DP master.
Note this behavior when changing the ET 200iSP to another configuration environment.
Remedy: Delete the flash memory of the interface module beforehand.
338
Range of values
1
• Yes
• No
• Use substitute value
• Keep last value
• 0
• 1
• Enabled
• Disabled
• Enabled
• Disabled
• Enabled
• Disabled
• Enabled
3
• Disabled
DANGER
Default
No
Use substitute value
0
Enabled
Enabled
Enabled
Disabled
Operating Instructions, 11/2022, A5E00247483-AK
Applicability
Channel 0
Channel 2
Channel
Channel
Channel
Channel
Channel
Module
ET 200iSP