Configuration Of Device Diagnostics For Profibus; Station Status 1 To 3 For Profibus - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Commissioning and Diagnostics
7.13 Diagnostics with STEP 7 with PROFIBUS
The CPU interrupts the processing of the user program and processes the diagnostic block OB56.
The event which led to the triggering of the interrupt is entered in the start information of the
OB56.
7.13.5

Configuration of device diagnostics for PROFIBUS

Table 7-27
Byte
Byte 0
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
... Byte 11
Byte 12
... Byte 24
Byte 25
...
Byte z
...
up to max. byte 95
If you configure with the GSD file, you may deselect this diagnostics.
1
7.13.6

Station status 1 to 3 for PROFIBUS

Definition
The station statuses 1 to 3 provide an overview about the status of a DP device.
202
Configuration of the device diagnostics for DPV0, S7 DP and DPV1
Description
Station status 1 to 3
See section "Station status 1 to 3 for PROFIBUS (Page 202)"
Master PROFIBUS address
See section "Master PROFIBUS address (Page 204)"
High byte
Low byte
Identifier-related diagnostics
See section "Identifier-related diagnostics in PROFIBUS (Page 205)"
Module status
1
See section "Module status in PROFIBUS (Page 206)"
Channel-related diagnostics (3 bytes per channel)
See section "Channel-related diagnostics with PROFIBUS (Page 207)"
H status only with S7-400H and standard redundancy
max. 6 bytes
See section "H status with PROFIBUS (only for S7-400H and standard redundancy)
(Page 211)"
Interrupts (only 1 interrupt per device diagnostic telegram possible)
max. 48 bytes
Interrupts are only supported if you configure the ET 200iSP with STEP 7 as S7 DP
or DPV1 device.
See section "Interrupts in PROFIBUS (Page 212)"
Manufacturer's ID
See section "Manufacturer's ID
(Page 204)"
1
1
Operating Instructions, 11/2022, A5E00247483-AK
ET 200iSP