Configuring The Profinet Connection; Configuring Profibus Dp Address - Siemens SIMATIC ET 200iSP Operating Instructions Manual

7.11.3

Configuring the PROFINET connection

Properties
With the PROFINET IO parameters you define at which address the ET 200iSP distributed I/O
device is addressed at the PROFINET IO.
Requirements
• The network parameters are set in the hardware configuration of the interface module and
are downloaded to the interface module.
• An IO controller with a PROFINET IO system and an ET 200iSP is created.
• The required network address and the subnet mask are known.
• The MAC address of the IM 152-1PN device is known.
• The rules for the configuration of Ethernet interfaces must be observed.
• HW-Config is open.
Setting the network configuration
1. Select the "IM 152-1PN", right-click it and select "Object properties".
The "Properties - IM 152-1PN" dialog box opens.
2. In the "Nodes in PROFINET IO system" area, click "Ethernet".
The "Properties - Ethernet interface IM 152-1PN" dialog box opens.
3. Enter the IP address in the "IP address" input field.
4. In the "Subnet" area, mark the "Plant bus" entry and click "OK".
5. In the "Properties – IM 152-1PN" dialog box, click "OK".
For an online connection to the automation system and connected ET 200iSP, you can search for
the station using the MAC address.
Then load the station.
Changing the network configuration
1. Proceed as described for "Set network configuration". If necessary, a STOP of the station/bus
system is required.
7.11.4

Configuring PROFIBUS DP address

Properties
With the PROFIBUS DP address you define under which address the ET 200iSP distributed I/O
device is addressed at the PROFIBUS RS 485-IS.
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK
Commissioning and Diagnostics
7.11 Commissioning and starting up the ET 200iSP
179