Network Interface Module; Profinet Interface Module Im 152-1Pn - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Network interface module

12.1

PROFINET interface module IM 152-1PN

Article number
6ES7152-1BA00-0AB0
Properties
The interface module IM 152-1PN has the following properties:
• Operation as IO device
• Preparing the data for the installed electronic modules
• The PROFINET IO configuration can be set via the network.
• Switching off the DC 24 V supply voltage at the terminal module TM-PS-A also switches off
the interface module.
• The maximum address space is 244 bytes for inputs and 244 bytes for outputs.
• Update firmware via PROFINET IO
• Redundancy
• Connecting the station of the ET 200iSP to PROFINET IO via fiber-optic cables (up to 3 km in
length)
• Redundant connection (MRP, S2, R1 system redundancy)
• Backing up the parameters of the electronic modules:
– The parameters / data are saved in the interface module.
• Startup
– After switching on the power supply of the station, the interface module distributes the
– Next, the connection to the network is enabled and the automation system is
– Only when the station exchanges data with the IO controller are the substitute values (of
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK
saved parameters/data to the electronic modules (e.g. substitute values for the output
modules).
commissioned by the IO controller.
the flash memory) replaced with the actual data of the IO controller.
12
277