Siemens SIMATIC ET 200iSP Operating Instructions Manual page 240

General technical specifications
9.2 Standards and certifications
Use in industrial environment
Table 9-1
Industry
Use in residential areas
Note
The distributed I/O system ET 200iSP is intended for use in industrial environments; when used
in residential areas, it can affect radio/television reception.
If you use the ET 200iSP in residential areas, then you must ensure the values of the EN
61000-6-3 measured according to EN 55016-2-3 for emission of radio frequency interference.
Individual measures are, for example:
• Installation of the ET 200iSP in grounded control cabinets/switch boxes
• Use of filters in supply lines
Approvals
ATEX- direc‐
tive
IECEx appro‐
val
INMETRO
FM approval
cULus ap‐
proval
CCC Ex ap‐
proval
240
Use in industrial environment
Area of application
R
Interference emission
EN 61000-6-4:2007 + A1:2011
KEMA 04ATEX2242 (ET 200iSP system)
The module markings are described in the specifications.
See technical specifications of the ET 200iSP modules.
See technical specifications of the ET 200iSP modules.
See technical specifications of the ET 200iSP modules.
R
Factory Mutual Research (FM)
See technical specifications of the ET 200iSP modules.
Underwriters Laboratories Inc.
See technical specifications of the ET 200iSP modules.
See technical specifications of the ET 200iSP modules.
Operating Instructions, 11/2022, A5E00247483-AK
Requirement for
Interference immunity
EN 61000-6-2:2005
ET 200iSP