Compatible Electronic Modules - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Network interface module
12.1 PROFINET interface module IM 152-1PN
Parameters IM 152-1PN
Diagnostic interrupts 1
Hardware interrupts
1)
Edge evaluation event enter‐
ing state
2
Data format
Noise suppression
Temperature unit
Slot reference junction 1 to 2
Input reference junction 1 to 4 •
Advanced diagnostics
Identifier-related diagnostics
Module status
Channel-related diagnostics
It may or may not be possible to edit these parameters, depending on the configuration tool used.
1
Configurable only in HW Config and when you operate the ET 200iSP on PROFINET IO and when time stamping is also enabled
2
for the automation system.
12.1.2

Compatible electronic modules

The following electronic modules can be used with IM 152-1PN:
Module
8 DI NAMUR
4 DO DC23.1V/20mA
4 DO DC23.1V/20mA shut down "H"
4 DO DC17.4V/27mA
4 DO DC17.4V/27mA shut down "H"
4 DO DC17.4V/40mA
4 DO DC17.4V/40mA shut down "H"
282
Range of values
• Disable
• Enable
• Disable
• Enable
• Rising edge (0-->1)
• Falling edge (1-->0)
• Channel-specific
• SIMATIC S7
• 50 Hz
• 60 Hz
• Celsius
• Fahrenheit
• None
• 2 to 33
RTD on channel 0
• RTD on channel 1
• RTD on channel 2
• RTD on channel 3
Yes/No
Enable / disable
Enable / disable
Enable / disable
6ES7131-7RF00-0AB0
6ES7132-7RD00-0AB0
6ES7132-7RD01-0AB0
6ES7132-7RD10-0AB0
6ES7132-7RD11-0AB0
6ES7132-7RD20-0AB0
6ES7132-7RD21-0AB0
Default
Disable
Disable
Rising edge (0-->1)
SIMATIC S7
50 Hz
Celsius
None
RTD on channel 0
No
Enable
Enable
Enable
Article number
Operating Instructions, 11/2022, A5E00247483-AK
Applicability
ET 200iSP
ET 200iSP
ET 200iSP
Module
Channel
ET 200iSP
ET 200iSP
ET 200iSP
ET 200iSP
ET 200iSP
ET 200iSP
No: 29 bytes for IM 152-1PN
Yes: 96 bytes for IM 152-1PN
Diagnostics frame
ET 200iSP- only IM 152-1PN
ET 200iSP- only IM 152-1PN
ET 200iSP- only IM 152-1PN
Compatible
Yes
No
Yes
No
Yes
No
No
ET 200iSP