Siemens SIMATIC ET 200iSP Operating Instructions Manual page 156

Commissioning and Diagnostics
7.1 Basics of commissioning and diagnostics
②
Cyclic data exchange:
• Configuration
• Parameters
• Read identification and maintenance data
• Diagnostic interrupts
③
Acyclic data exchange:
• Parameters
• Read and write identification and maintenance data
• HART access
Figure 7-1 Principle of project engineering
Configuring
Configuration is the configuration and parameter assignment of the ET 200iSP with the PG.
Configuring
• Configuration with PROFINET connection
During configuration you set the properties of the IO device (e.g. network parameters,
module selection in HW Config). You configure the ET 200iSP with
– Engineering tool (e.g. STEP 7; PCS 7)
• Configuration with PROFIBUS connection
Only set the basic properties of the DP device during configuration (e.g. network parameters,
module selection in HW Config). You configure the ET 200iSP with
– Engineering tool (e.g. STEP 7; PCS 7)
– COM PROFIBUS or with a suitable engineering tool (via the GSD file).
Note
Slots as reserve for changes during operation (CiR)
If you want to make changes during operation, you must observe the following:
Adjacent slots are not permitted as spare slots if the spare slots are followed by configured
electronic modules.
156
Operating Instructions, 11/2022, A5E00247483-AK
ET 200iSP