4
Parts Replacement and Cleaning > Image Formation System > Reinstalling the ITB > Procedure
11) PuII the ITB Pressure Release Lever and Install the harness.
• 1 edge saddle
• 3 wire saddles
x4
CAUTION:
Make sure that there is no gap between the ITB Pressure Release Lever and the Plate.
4
Parts Replacement and Cleaning > Image Formation System > Reinstalling the ITB > Procedure
F-4-180
Space
CAUTION:
Make sure that the shaft is fixed to the fixing member.
CAUTION:
Make sure that the hook is fixed to the plate.
12) Turn over the ITB Unit.
13) Install the ITB Cleaning Unit.
4-129
4-129