Canon imageRUNNER ADVANCE C5255 Series Service Manual page 157

2
Technology > External Auxiliary System > Controls > Quick Startup
possibility to come in contact with the PCBs above. PCBs may get damage. If a conductive
material comes in contact with the PCB, short circuit may occur in the PCB, and may cause
damage on it.
The following illustration is used at the place where attention needs. When the following label
is affixed, be sure to disconnect the plug from outlet or turn OFF the Breaker.
Quick Start
Plug Off
In addition, quick startup is not performed under the following conditions.
At first startup after the AC Power Plug is connected to the outlet
Under the following conditions (settings), the machine always starts up normally (even quick startup
is ON).
When any of the following devices is connected.
• EFI Controller
• Serial Interface Coin Vendor
• Wireless LAN
When any of the following network settings is set to "ON".
• RARP
• BOOTP
• IPsec
• IPv6
• NetWare
• AppleTalk
2 Technology > External Auxiliary System > Controls > Quick Startup
F-2-154
As for startup right after shutting down of the machine under any of the following conditions, it starts
up normally (even quick startup is ON).
FAX
• There is a fax transmission reservation.
• Within a specified period of time (10 seconds) from disconnection of a fax line
• Within a specified period of time (10 seconds) from non-detection of reception from a fax
line
• Within a specified period of time (10 seconds) from putting down the fax sub device or
handset
MEAP
During execution of MEAP application which prohibits moving to Deep Sleep
A scheduled processing is reserved on MEAP.
Job processing
• During print/scan job processing
• During SEND job processing
• During I-Fax communication/job processing
• During report job processing
• During forwarding transmission job/reception job processing
• During processing of data storage to Advanced Box
• During fax communication/phone communication
• During distribution of device information
• During Box backup
• During export/import by RUI
• During opening/reading/writing file of Advanced Box (common with SMR/WebDAV)
• During rebuilding with the HDD Data Encryption/Mirroring Board installed
Others
• When the machine state remains unchanged for more than 110 hours after turning ON the
power as quick startup or turning OFF the power.
• Within a specified period of time (20 seconds) from turning OFF the Main Power Supply
Switch
• After moving to the Settings/Registration screen of service mode or RUI
• After changing the user mode that requires restart
• The machine is shut down from RUI
• When an error occurs
• When resource downloader is active
• In printer/scanner limited functions mode
• When a login application is switched by SMS
• A license has been registered.
• Startup by pressing the Control Panel Key
2-119
T-2-75
2-119