Canon imageRUNNER ADVANCE C5255 Series Service Manual page 434

4
Parts Replacement and Cleaning > Image Formation System > Removing the ITB > Procedure
3) Pull the ITB Pressure Release Lever to the front.
4) Remove the harness.
• 3 wire saddles
• 1 edge saddle
x4
5) Remove the rear pin.
• 1 screw
NOTE:
Place the ITB cover upside down on the place where the ITB Unit will be stood.
4 Parts Replacement and Cleaning > Image Formation System > Removing the ITB > Procedure
F-4-143
F-4-144
6) Lift the ITB and stand it on the ITB Cover.
CAUTION:
• Make sure that it is removed from the front and rear hooks.
• Make sure to align the claw of the ITB Cover with the cut-off of protection sheet.
• In order to prevent the ITB from being damaged, be sure to place a sheet of paper
between the ITB Unit and the ITB Cover as needed.
• 2 claws
x2
Hooks
ITB cover
Claws Paper
Paper
4-114
Claw
F-4-145
4-114