Canon imageRUNNER ADVANCE C5255 Series Service Manual page 403

4
Parts Replacement and Cleaning > Main Controller > Removing the HDD > Actions after Replacement
■ Actions after Replacement
1) HDD format
1-1) Start the machine in safe mode (turn ON the main power switch while simultaneously
pressing 2+8 keys).
1-2) Execute Formatting All Partitions using SST.
2) Download the system software (refer to Upgrade).
3) Initialize the key/certificate/CA certificate.
(Lv.2) COPIER > FUNCTION > CLEAR > CA-KEY
4) Turn OFF and then ON the power.
5) Restore the backup data.
Use the remote UI. Follow the steps below to specify the DCM file stored earlier.
Settings/Registration > Management Settings > Data Management > Import/Export All >
Import
Enter the encryption password entered at exporting, and select "Start Importing". Turn OFF
and then ON the power after importing.
6) When the user generates and adds the encryption key, certificate and/or CA certificate,
request the user to generate them again.
7) Executing "Auto Adjust Gradation (Full Adjust)" Settings/Registration mode: Adjustment/
Maintenance > Adjust Image Quality > Auto Adjust Gradation
Points to note when using an HDD with system software already installed
Use of an HDD in which the system software of another machine (a machine of a
different serial number) is installed for a troubleshooting is possible if it is an HDD of a
model of iR-ADV C5255 series and later. However, be sure to format it after installing it.
Operation is not guaranteed if it is continued to be used as is.At installation, HDD must
be formatted. Therefore, it is not recommended to use an HDD which has been used
with another machine. If you use an HDD which has been used with another machine,
be sure to get agreement from user in advance that user data will be deleted.
In addition, an HDD used in iR-ADV C5255 series and later cannot be accessed from a
PC due to enhanced security.
4 Parts Replacement and Cleaning > Main Controller > Removing the HDD > Actions after Replacement
● When using the Card Reader and imageWARE Accounting Manager
1) Go to COPIER > FUNCTION> INSTALL > CARD and enter the numerical value of the
leading card which is used for Department ID.
Then, press "OK" button. (e.g.: If No.1 to No.1000 cards are used for Department ID, enter
"1" of the leading card.)
2) After turning OFF and ON the main power switch, perform the following operations from
Settings/Registration mode.
In Management Settings > User Management > Department ID Management > Page
Totals, be sure that "ID00000001" to "ID00001000" are created.
Set the following: Preferences > Network > TCP / IP Settings > IPv4 Settings>IP Address
Settings > IP Address, Gateway Address, Subnet Mask
In Management Settings > User Management> System Manager Information Settings>
System Manager ID and System PIN, register any number for them. Then, turn OFF and
ON the main power switch.
If "System Manager ID" and "System PIN" are not registered, "card registration to device"
cannot be executed for the imageWARE Accounting Manager setting operation.
3) Download the card ID from imageWARE Accounting Manager to the Main Body again.
4) After downloading is completed, go to Management Settings > User Management >
Department ID Management > Page Totals. Be sure that only the downloaded card ID is
displayed.
5) Print using the user card registered from imageWARE Accounting Manager.
Be sure that the card information used for the target devices of imageWARE Accounting
Manager is collected.
Points to Note when Using the System Software-installed HDD When using the HDD which
was installed the system software of the other machine (different serial number), be sure to
format the HDD after the installation.
If the HDD is not formatted, the operation cannot be guaranteed.
4-83
4-83