Dtc B1032: Driver Air Bag Initiator Circuit Resistance Low - Suzuki Grand Vitara 2011 Manual

8B-33 Air Bag System:

DTC B1032: Driver Air Bag Initiator Circuit Resistance Low

Wiring Diagram
Refer to "DTC B1031: Driver Air Bag Initiator Circuit Resistance High".
CAUTION
!
Be sure to observe instructions under CAUTION in "Air Bag Diagnostic System Check Flow".
DTC Will Set when
The combined resistance of the driver air bag (inflator) module, contact coil assembly, harness wiring and connector
terminal contact is below a specified value for specified time.
Flow Test Description
Step 1: Check whether malfunction is in contact coil and driver air bag (inflator) module or the others.
Step 2: Check driver air bag (inflator) module initiator circuit.
Step 3: Check whether malfunction is in contact coil or driver air bag (inflator) module.
DTC Troubleshooting
Step
1 1) With ignition switch OFF, disconnect contact coil
connector located under of the steering column.
2) Check proper connection to contact coil at terminal in
"G26" or "G27" connector.
3) If OK, then connect special tools (B) and (C) to "G26"
connector (For vehicle without cruise control system [A])
or special tools (B) and (D) to "G27" connector (for
vehicle with cruise control system [B]) disconnected in
Step 1).
Special tool
(B): 09932–75010
(C): 09932–78340
(D): 09932–77320
[A]
(C)
BASE OF COLUMN
(B)
4) Check SDM DTC.
With ignition switch ON, is DTC B1032 indicated?
Action
[B]
"G26"
PASSENGER
DRIVER
(D)
BASE OF COLUMN
(B)
Yes
Go to Step 2.
"G27"
I5JB0A820026-02
S6JB0A8204016
No
Go to Step 3.