Required Electric Strength Of Connected Cables - Bosch rexroth Sytronix SvP 7030 IMC Operating Manual

Sytronix SvP 7030 IMC
108 / 186
Connecting the Sytronix system SvP 7030 electrically
Designation
Mains input continuous current at U
P (three-phase, without mains choke)
DC_cont
Mains input continuous current at U
P (three-phase, with mains choke)
DC_cont
Mains fuse according to EN 60204-1 (three-
phase, without mains choke)
Mains fuse according to EN 60204-1 (three-
phase, with mains choke)
Required wire size in accordance with NFPA 79
and UL 508 A (internal wiring);
Mains connected load at U
(three-phase, without mains choke)
Mains connected load at U
(three-phase, with mains choke)
1) Otherwise, use XNL mains choke
2) 3) Find interim values by interpolation
4) Copper wire with PVC insulation (conductor temperature 90 °C; Ta ≤ 40 °C)
in accordance with NFPA 79 chapter 12 and UL 508A chapter 28
External braking resistor/integrated braking transistor
Table 83: Minimum requirement on external braking resistor/integrated braking transistor
Designation
Minimum resistance
Maximum resistance
Braking transistor continuous power
Absorbable regenerative power of braking tran-
sistor
7.5.19

Required electric strength of connected cables

● Lines at connection points XD01, XD02, XD03, XD04, XD10, XG03, XZ03:
● Lines at connection points XG and XF:
Bosch Rexroth AG
and
LN_nom
2)
and
LN_nom
3)
4)
and P
LN_nom DC_cont
and P
LN_nom DC_cont
– Dielectric strength to basic insulation
– Operating voltage designed for mains voltage and DC bus voltage (con-
ductor/conductor: 500 VAC, conductor/ground: 300 VAC)
– Operating voltage of the corresponding control signal or communication
signal
– Lines run on the left or right side of the device have to be run at a
minimum distance of d
If this distance is less than the minimum distance, these lines must have
been designed for the mains voltage and DC bus voltage.
Symbol Unit
I A
LN
I A
LN
A
A
A AWG
LN
S kVA
LN
S kVA
LN
Symbol Unit
R ohm
DC_Bleeder_min
R ohm
DC_Bleeder_max
P kW
BD
kWs
W
R_max
≥ 10 mm to the device.
hor
XCS*-W0250
141.5
160.8
200
200
tbd
98
111.4
XCS*-W0250
4
75
30
5000
RE 62312-B, 03.2022