Table of Contents
Advertisement
Sytronix SvP 7030 IMC
156 / 186
Initial commissioning
8.1.1
Filling the Sytronix system
You will require an approved hydraulic fluid: The machine or system manufac-
turer can provide you with precise data of the hydraulic fluid.
8.1.2
Commissioning of the pump
General information on how to commission the pump
When commissioning the internal gear pumps PGH/PGH/PGM or axial piston
units A10FZO, respectively, observe the operating instructions for the hydraulic
system.
Commissioning of the pump requires knowledge in the field of mechanical
systems and hydraulics.
● Only a qualified expert may commission the pump.
If the pump has not been mounted correctly, persons may be injured and the
product or system can be damaged during commissioning of the pump.
● Ensure correct mounting of the pump by qualified personnel before you
Preparing commissioning
● Make sure that fluid can be aspired via the suction channel without any
● Inspect the mounting elements for proper fit.
● Check the hydraulic fluid reservoir for cleanliness.
● Fill the system with hydraulic fluid according to the manufacturer's instruc-
● Make sure that the piping is clean and tightly mounted.
● Make sure that the direction of rotation of the motor corresponds to the
● If pressure builds up, check the direct functions/movements on the basis of
Bosch Rexroth AG
Spilled hydraulic fluid!
NOTICE
Discharging or spilling hydraulic fluid while filling the
Sytronix system can lead to environmental pollution and
contamination of the groundwater.
−
When filling in and changing the hydraulic fluid,
always place an oil drain pan under the Sytronix
system.
−
Observe the information in the safety data sheet for
the hydraulic fluid and the instructions provided by
the system manufacturer.
commission the pump.
obstructions.
tions. Use filters with the required minimum retention rate.
direction of rotation of the pump. If the shaft cannot be seen, operate the
pump in the jog mode to see, whether pressure builds up (display in Indra-
Works)
a hydraulic circuit diagram.
RE 62312-B, 03.2022
Advertisement
Table of Contents
