Bosch rexroth Sytronix SvP 7030 IMC Operating Manual page 80

Sytronix SvP 7030 IMC
80 / 186
Connecting the Sytronix system SvP 7030 electrically
Power requirement
Device
Basic
device
XCS W0023 12.1
W0054 54
W0070 47
W0100 35.6
W0120 35.6
W0150 61
W0180 75
W0210 71.5
...
W0280
Requirements on the 24 V power supply unit
PELV (Protective Extra-Low Voltage) for the 24 V power supply unit
Use a power supply unit or a control transformer with PELV protection
according to IEC 60204-1 (section 6.4) for the 24 V supply of devices of the
ctrlX DRIVE drive family.
For the scope of CSA/UL, a UL508-certified power supply unit has to be used.
The following technical data contain the basic requirements on the 24 V power
supply unit:
● Output voltage or output voltage range
● Continuous powerthat the 24 V power supply unit has to provide during
● Peak currentthat the 24 V power supply unit has to supply when switching
Required continuous power
The continuous power of the 24 V power supply unit has to be greater than the
sum of the power consumptions P
To select the 24 V power supply unit, determine the continuous current I
all components:
I
N3
(P
The calculated current I
power supply unit.
The power consumption is specified as the maximum value of the respective
component and can occur at individual components .
In drive packages with several components, the occurring power consumption
under statistical assumptions will be lower than the calculated one.
Bosch Rexroth AG
Options
ET EC T0 X3
1)
(CORE)
1.4 0.9 0.5 9.8
operation
on
= P / U
N3 N3
: power consumption of all components)
N3
N3
Power requirement [W]
External/customer-specific
Digital Encoder
output (EC)
0...12 0...3.6
1) ctrlX DRIVE per device; ctrlX DRIVE plus: per axis
2) ctrlX DRIVE with CORE and optional USB on-the-go
of the components to be supplied.
N3
corresponds to the continuous current of the 24 V
Panel
Encoder Dynamic XDP1
(onboard) input
(T0, M5)
0...2.4 0...7.2 0.9
1.9
RE 62312-B, 03.2022
2)
of
N3