Demounting And Replacement; Required Tools; Preparing Demounting; Demounting - Bosch rexroth Sytronix SvP 7030 IMC Operating Manual

12

Demounting and replacement

12.1

Required tools

The product can be demounted using standard tools. No special tools are nec-
essary.
12.2

Preparing demounting

1.
2.
12.3

Demounting

Proceed as follows to demount the Sytronix system:
1.
2.
3.
4.
5.
6.
12.4

Preparing the components for storage or further use

Proceed as described in ⮫ Chapter 6 "Transport and storage" on page 35.
RE 62312-B, 03.2022
Preparing the components for storage or further use
High voltage!
CAUTION
Risk of electric shock by contact with live parts!
−
Disconnect all parts of the system from the power
supply.
Decommission the entire system as described in the general instructions
for the machine or system.
Depressurize the hydraulic system according to the instructions of the
machine or system manufacturer.
Spilled hydraulic fluid!
NOTICE
Discharging or spilling hydraulic fluid while filling the
Sytronix system can lead to environmental pollution and
contamination of the groundwater.
−
When filling in and changing the hydraulic fluid,
always place an oil drain pan under the Sytronix
system.
−
Observe the information in the safety data sheet for
the hydraulic fluid and the instructions provided by
the system manufacturer.
Make sure that the hydraulic system is depressurized and the Sytronix
components are disconnected from the power supply.
Check that the Sytronix system has cooled down sufficiently so that it can
be removed without any risks.
Loosen the lines and collect the escaping hydraulic fluid in the collector
provided for this purpose.
Demount the Sytronix system. Use suitable lifting gear for this.
Drain the Sytronix system completely.
Plug all openings.
Sytronix SvP 7030 IMC
Bosch Rexroth AG
169 / 186