Table of Contents
Advertisement
● If unsuitable products are installed or used in safety-relevant applications,
● You may commission the product only when it has been established that
2.6
Product and technology-related safety instructions
RE 62312-B, 03.2022
Product and technology-related safety instructions
unintended operational states can occur in these applications, which can
cause personal injury and damage to property. Therefore, please only use a
product for safety-relevant applications if this use is expressly specified and
permitted in the documentation of the product.
the final product (for example, a machine or system), in which the Rexroth
product is installed, complies with national regulations, safety regulations
and standards relevant for the application.
System parts under pressure and ejecting hydraulic
WARNING
fluid!
When working on hydraulic systems with stored energy
(e.g. accumulators) hydraulic components may still be
under pressure even after the pressure supply was
switched off. During installation and demounting, com-
ponents or parts may be hurled around and cause per-
sonal injuries and/or damage to property. There is more-
over the risk of serious injury caused by a powerful,
ejecting hydraulic fluid jet.
−
Before working on the hydraulic product ensure that
the hydraulic system is depressurized and the elec-
trical control de-energized.
−
Completely depressurize machines and systems
before working on hydraulic products.
Non-compliance with functional safety!
WARNING
Hydraulic components control movements in machines
or systems. In the event of mechanical and electrical
faults, e.g. power supply failure due to lightning or fluc-
tuations in the power supply, the machine can start up
unexpectedly and perform uncontrolled movements and
thus cause personal injuries.
−
When setting up your circuit, observe functional
safety, e.g. according to EN ISO 13849.
−
If necessary, fit light barriers or safety guards for pro-
tection against dangerous movements.
−
Observe the notes in the project planning manual and
in the data sheet with regard to protection and appli-
cation.
−
If an accumulator is provided, install a check valve
and an accumulator safety block.
Sytronix SvP 7030 IMC
Bosch Rexroth AG
13 / 186
Advertisement
Table of Contents
