Table of Contents
Advertisement
Safety
2
Safety
2.1
Liability
The manufacturer is not liable for damages, losses, costs or expenses incurred by
any user of the EVSE (e.g. the qualified installation engineer or owner of the EVSE)
if such damages, losses, costs or expenses result from a failure to comply with the
applicable safety instructions given by the manufacturer, including, but not limited
to, the following:
•
Power outages or disruptions to the electrical supply to the EVSE.
•
Accumulation of dirt or ingress of foreign substances within the EVSE.
•
Corrosion of component parts.
•
Upgrades enhancements or modifications to the equipment or its use.
•
Damage to software or hardware due to any IT security problem, such as but not
limited to a virus breakout or malicious hacking of the system.
•
Damage or failure of equipment caused by vermin, insect infestations or the like.
•
Damage or failure resulting from faults in some other equipment connected to
the scope of work.
•
Damage or loss caused by hazards such as fire, flood, storm or the like or
spillage or leakage of chemicals or harmful substances onto the EVSE.
•
Fault tracing caused by problems from a source external to the scope of work.
•
Unprofessional or incorrect installation, installation not complying to standards,
or installation not following the installation instructions contained in the
product specific manual.
•
Improper operation (in breach of the technical requirements or specifications or
manuals of the product), negligence or repairs carried out by the Owner (or any
third party not authorized by ABB).
•
Non-compliance with the applicable safety regulations or other legal standards
by other parties than ABB.
•
Insufficient ventilation of the EVSE.
•
Operation of the EVSE outside of its design conditions.
•
Relocation of the EVSE from the original installation location or alteration of the
overall system design.
•
Only make changes to the EVSE if the manufacturer approves in writing of the
changes.
2.2
General safety instructions
•
Only perform the procedures as indicated in this document.
•
Only perform service by a qualified installation engineer or use the EVSE when
you are fully qualified to do so.
•
Comply with the applicable laws and local rules in this manual.
If and to the extent permitted by law, in case of inconsistency between any
requirements or procedure contained in this document and any such applicable
laws and local rules, comply with the stricter applicable laws and local rules,
requirements and procedures specified in this document.
14
HVC 200/300/360-EN | 002
Advertisement
Table of Contents
