Table of Contents
Advertisement
Safety instructions
These are the safety instructions which you must obey when you install and operate the drive
and do maintenance on the drive. If you ignore the safety instructions, injury, death or damage
can occur.
Use of warnings and notes in this manual
Warnings tell you about conditions which can cause injury or death, or damage to the equipment.
They also tell you how to prevent the danger. Notes draw attention to a particular condition or
fact or give information on a subject.
The manual uses these warning symbols:
Electricity warning tells about hazards from electricity which can cause injury or death, or
damage to the equipment.
General warning tells about conditions, other than those caused by electricity, which can
cause injury or death, or damage to the equipment.
Electrostatic sensitive devices warning tells you about the risk of electrostatic discharge
which can cause damage to the equipment
General safety in installation, start-up and maintenance
These instructions are for all personnel that install the drive and do maintenance work on it.
WARNING! Obey these instructions. If you ignore them, injury or death, or damage to the
equipment can occur.
Use safety shoes with a metal toe cap to avoid foot injury. Wear protective gloves and long
•
sleeves. Some parts have sharp edges.
Handle the drive carefully.
•
Beware of hot surfaces. Some parts, such as heatsinks of power semiconductors, remain
•
hot for a while after disconnection of the electrical supply.
Keep the unit in its packaging until you install it. After unpacking, protect the drive module
•
from dust, debris and moisture.
Also protect the installed drive against dust and burrs. Electrically conductive debris inside
•
the drive may cause damage or malfunction.
Vacuum clean the area below the drive before the start-up to prevent the drive cooling fan
•
from drawing the dust inside the drive.
Do not cover the air inlet and outlet when the drive runs.
•
Make sure that there is sufficient cooling.
•
See the ACQ580-01 Hardware Manual (
•
Manual (
3AXD50000045935
Before you connect voltage to the drive, make sure that the doors are closed. Keep the
•
doors closed during the operation.
Before you adjust the drive operation limits, make sure that the motor and all driven
•
equipment can operate throughout the set operation limits.
Before you activate the automatic fault reset or automatic restart functions of the drive
•
control program, make sure that no dangerous situations can occur. These functions reset
3AXD50000044862
) for more information.
) or ACQ580-31 Hardware
2
Advertisement
Table of Contents
