Javad Maxor User Manual page 60

C O N F I G U R A T I O N
2
Radio Configuration
Notice: The Base and internal Maxor (Rover) PDL radios must be
configured with the same Channels, Radio Link
characteristics (except Digisquelch) and Serial Interface
parameters. Typically, Digisquelch is set on High for
Rover and Low for Base station.
Click the Serial Interface tab and set the following parameters (Figure 2-32):
14.
•
•
Notice: Parity should always be set to None.
•
2-26 Maxor User's Manual
Figure 2-31. PDL Radio Link Tab
Baud Rate - 38400
Parity - None
Mode - Transparent w/EOT Timeout
www.javad.com