Bluetooth Problems - Javad Maxor User Manual

Bluetooth Problems

The following are some of the most commonly encountered error messages.
BTCONF reports the error messages in the status bar.
www.javad.com
Problem
The receiver does not start data logging.
Causes
The receiver has
already logged 512
files into the internal
memory.
Error Message
Can't find receiver.
Causes
The receiver is turned
off.
If using a cable, the
cable's connectors are
improperly attached.
If using a cable, the
cable is damaged.
The COM port the
receiver is attached to
differs from the one
selected in BTCONF.
The receiver port used
for connection is not in
Command mode.
Solutions
• Delete unnecessary files (see "Deleting Files" on
page 4-10).
• Use the AFRM feature. See "Automatic File Rotation
Mode (AFRM) parameters" on page 2-18.
Solutions
Ensure the receiver has power and is turned on.
• Check that the cable connector is attached to the correct
serial port.
• Unplug the cable, then securely and properly reconnect
it to the receiver.
• Use an undamaged cable.
• Contact your Dealer to purchase a new cable.
Ensure that the RS232 cable is attached to the COM port
specified in the BTCONF communication port dropdown
list. See "Bluetooth Module Configuration" on page 2-31
for details.
1.
Connect your receiver and a computer using a free port
(see"Connecting the Maxor and a Computer" on
page 2-8) and start PCView.
2.
Click Configuration->Receiver->Ports.
3.
Change the Input for the serial port used for connection
to Command.
TR O U B L E S H O O T I N G

Bluetooth Problems

Maxor User's Manual 5-7