Javad TRIUMPH-1M User Manual

Configure as a base / rover with repeater using jmobile

Hide thumbs Also See for TRIUMPH-1M:

Download this manual

How to configure

TRIUMPH-1M as a

Base/Rover

with Repeater using

JMobile

Version 1.0

Last Revised March 2, 2019

All contents in this manual are copyrighted by JAVAD GNSS.

stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express

written consent from JAVAD GNSS.

Need help?

Do you have a question about the TRIUMPH-1M and is the answer not in the manual?

Page 1 Version 1.0 Last Revised March 2, 2019 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved. The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express...
Page 2 TRIUMPH-1M as a Base HPT435BT as repeater TRIUMPH-1M as a Rover To configure HPT435BT as a repeater, the software JAVAD HPT Repeater Setup (available from Google Play) for Android devices could be used.
Page 3 How to configure TRIUMPH-1M as a Base Station 3. Setup the Base position. Find the three types of posi- with Repeater tioning: • Get From Receiver; • Get From Catalog; 1. To connect the Base to JMobile, use Bluetooth. • Set Coordinates.
Page 4 How to Configure TRIUMPH-1M as a Rover with 5. To set up the UHF radio with Repeater: Repeater • Check all settings; • Activate Repeater Mode (Use Repeater). 1. Connect to Rover by Bluetooth 1.6 Start Base Station: tap “Start” or “Restart station” if it was started early.
Page 5 3. Tap “Correction Source (Unknown)” and choose “My 5. Apply Settings: UHF Radio”. • Check Current UHF settings • Activate Repeater • Apply Changes 4. Check current UHF Settings and change it (press to 6. Start Rover: tap “Start”. UHF settings) www.javad.com...
Page 6 www.javad.com...