Maxor Configuration; Configuration->Receiver - Javad Maxor User Manual

C O N F I G U R A T I O N
2

Maxor Configuration

PCView. A timer begins to count up in the lower-right corner as well (Figure 2-
12).

Maxor Configuration

PCView is Javad's receiver configuration software, used to configure the
various parts of the Maxor receiver. Any settings made using PCView will be
saved in the receiver's memory, and will be reflected when you use the MinPad.
The full range of PCView configuration and function is outside the scope of this
manual.
Notice: Refer to the PCVIEW User's Manual to manage all
possible Maxor receiver configurations.
The following configuration is recommended for the most common
applications. However, you can select configuration parameters as needed for
your particular jobsite.
Notice: Click Apply after making any configuration change,
otherwise the receiver will not accept the change.
Connect your receiver and computer. See "Connecting the Maxor and a
1.
Computer" on page 2-8 for this procedure.
Once connected, click on Configuration->Receiver (Figure 2-13).
2.
2-12 Maxor User's Manual
Figure 2-12. PCView Connection Established
Figure 2-13. Configuration->Receiver
www.javad.com