Zero Power Mode; Checking Firmware Version - Javad Maxor User Manual

O P E R A T I O N
4

Checking Firmware Version

Turn on your receiver.
1.
Press the receiver's power key for more than four seconds and less than
2.
eight seconds. The STAT LED will be orange. The receiver enters Sleep
Mode.
Any activity on the RS232 port will turn the receiver on.
3.
Notice: If you press the power key for more than 14 seconds, it
will be ignored. This protects receiver operation against
stuck keys.

Zero Power Mode

When your Maxor is off, even in Sleep Mode, the power board will continue to
draw power from the batteries. This means that if you fully charge your
receiver, turn it off and store it, the receiver will drain its battery power in less
than two months. To stop the power board from draining the batteries, you can
put your receiver in Zero Power Mode.
Turn on your receiver.
1.
Press and hold the power key for more than 8 seconds, but less than 14
2.
seconds.
Release the power key when both LEDs become red. When the LEDs turn
3.
off, your receiver will be in Zero Power Mode.
Press the Reset key for about one second to return to Normal mode.
4.
Notice: When the internal batteries have completely discharged
and no external power is connected, the receiver will go
into Zero Power Mode automatically to prevent the
batteries from over discharging.

Checking Firmware Version

Use PC-View to check the firmware version of your receiver.
Notice: The Maxor receiver should be loaded with firmware
version 2.3 or newer.
Connect your receiver and computer. See "Connecting the Maxor and a
1.
Computer" on page 2-8 for this procedure.
4-16 Maxor User's Manual www.javad.com