Using Pcview To Clear Nvram; Changing Receiver Modes; Sleep Mode - Javad Maxor User Manual

4.
5.
6.

Using PCView to Clear NVRAM

1.
2.
3.
The receiver will automatically disconnect once the NVRAM is cleared.

Changing Receiver Modes

The Maxor receiver has four modes, two information modes and two power
modes:
• Normal Mode
• Extended Information Mode

• Sleep Mode

• Zero Power Mode
See "Information Modes" on page 4-6 for a description of Normal Mode and
Extended Information Mode.
Sleep Mode
In sleep mode, the power board continues to draw power from the batteries,
causing the batteries to drain over time. Put the receive in Zero Power Mode to
prevent this (see "Zero Power Mode" on page 4-16). Follow these steps to put
the Maxor into sleep mode.
www.javad.com
Wait until the STAT and REC LEDs are green
Wait until the STAT and REC LEDs blink orange.
Release the FN key while the STAT and REC LEDs blink orange.
Connect your receiver and computer. See "Connecting the Maxor and a
Computer" on page 2-8 for this procedure.
Click Tools->Clear NVRAM (Figure 4-11).
Click OK at the clear NVRAM confirmation dialog box. The REC LED
rapidly flashes green and red; the STAT LED flashes red.
Figure 4-11. Tools->Clear NVRAM
O P E R A T I O N

Changing Receiver Modes

Maxor User's Manual 4-15