Version 1.0 Last Revised March 9, 2017 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved.The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express...
JAVAD GNSS products. It is designed to as- owners. sist owners with the use of DELTA-3N and its use is DISCLAIMER OF WARRANTY – EXCEPT FOR subject to these terms and conditions (the “Terms and ANY WARRANTIES IN THIS MANUAL OR A WAR- Conditions”).
Software under the terms stated herein and in any case only with a single DELTA-3N Regulatory Information or single computer. You may not assign or transfer the...
864 GNSS channels of this receiver allow tracking Several other features provide under-canopy and low all current and future satellite signals. DELTA-3N is the signal strength reception. The DELTA receiver provides only receiver in the market that can track and decode the functionality, accuracy, availability, and integrity the QZSS LEX signal messages.
Page 6
• Two Event Markers • IRIG A134, A137, B124, B137 • External Reference Frequency Input/Output • Two LEDs, two function keys (TriPad) Power Specification • External power input • Power consumption: 4.5 Watt • Input voltage: +4.5 to +35 Volts www.javad.com...
Data and power ports take. DELTA-3N saves the last power status and restore it The DELTA receiver can be equipped according us- after voltage loss. ers needs and have different ports on the front and back panels.
To check the status of the internal batteries, view the site. If downloading the program(s) from the website, BAT LED or check the status using JAVAD GNSS soft- extract the program’s files into a folder on your hard ware. Check the BAT LED for battery status.
Page 9
This data is then pro- Establishing an USB connection cessed using post-processing software (for example, Make sure the computer has JAVAD GNSS’s USB Justin). driver installed (available from www.javad.com) be- When configuring receivers for RTK surveying, use fore continuing.
Page 10
Elevation mask Initial dynamic mode Select Dynamic (for 6. To set up the base station, open the Base tab and trajectory survey) set the following parameters: Antenna Phase Center Click Apply every time after the parameter was changed, Note: www.javad.com...
Page 11
Instead, the RTK en- gine will compute either a delayed RTK position (for the epoch to which the newly received RTCM/CMR message corresponds) or the current stand-alone po- www.javad.com...
The receiver configuration will be kept in the re- ceiver till you will change them or will clear NVRAM. Note: For detailed description of settings and parameters see NetView Software Manual.. TriPad Configuration The DELTA-3N’s simple user interface (TriPad) con- Figure 15. Funktion Key www.javad.com...
The point to which surveying with GNSS measures is called the Phase Center of the antenna. This is anal- ogous to the point at which a distance meter measures in a prism. A user must enter the prism offset to com- www.javad.com...
• The necessity of resolving carrier phase ambigu- in the field notes ities To start survey DELTA-3N should be set up on a tri- Generally, single-frequency receivers are used for pod or in a pole. baselines whose lengths do not exceed 15 kilometers (9.32 miles).
As JAVAD GNSS releases firm- Usually, the receiver will start to output the coordi- ware updates, loading these updates into the receiver nates of the antenna’s phase center along with the solu-...
Press and hold the power button for about 4 to Loading OAFs 8 seconds. Release the power button while con- JAVAD GNSS dealers provide customers with OAF tinuing to hold the FN button. files. For any OAF related questions, E-mail at sup- •...
Base and Rover receivers must be loaded with the same firmware version. Use the latest firmware version, available for download from the JAVAD GNSS web- site, to ensure your receiver has the most recent updates. To load new firmware use NetView.
Check that the radio modem’s antenna is securely and properly connected to the antenna connector. Check that the radio modem’s antenna is undamaged. If damaged, contact your JAVAD GNSS dealer to re- place the antenna. The specified baud rate is incompatible with the baud rates the receiver supports.
Power Source and have an output rated for 4,5...35 V DC, not less than 2A. This may not be the same range as other JAVAD GNSS products with which you are familiar. Warning: To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instruc- tions unless you are qualified to do so.
The purchaser’s sole remedy shall be replacement as Warning: The owner should periodically test this product to provided above. In no event shall JAVAD GNSS be lia- ensure it provides accurate measurements. Inform JAVAD GNSS ble for any damages or other claim including any claim immediately if this product does not function properly.