Receiver Problems - Javad Maxor User Manual

Receiver Problems

The following are some of the most commonly encountered receiver problems.
www.javad.com
Problem
The receiver does not power up.
Causes
The receiver may be in
Zero Power Mode.
If no external power
source used, batteries
may be discharged.
The receiver has an
external power source,
but internal batteries
are discharged.
The receiver may have
a defective charger or
defective internal
batteries.
Problem
The receiver cannot establish a connection to a computer or external controller.
Causes
The Daisy Chain mode
is still active.
The cable is not
properly plugged in.
Solutions
Press the Reset key.
Connect a fully charged external power source and retry.
See "Powering the Maxor" on page 2-2.
Charge the batteries overnight. See"Powering the Maxor"
on page 2-2.
If after charging your internal batteries overnight, and your
Maxor is not powering, contact JNS Customer Support for
advice.
Solutions
See Step 20. on page 2-28 for the procedure to turn off the
Daisy Chain.
• Check that the cable connector is attached to the correct
serial port.
• Unplug the cable, then securely and properly reconnect
it to the receiver.
• See "External Components" on page 1-11 and
"Connector Specifications" on page B-9 for information
on the receiver's connectors.
TR O U B L E S H O O T I N G

Receiver Problems

Maxor User's Manual 5-3