Javad Maxor User Manual page 54

C O N F I G U R A T I O N
2
MinPad Configuration
specify that the corresponding log file will start with a static or kinematic
occupation, respectively.
Data Recording Auto-start parameter
These radio buttons allow you to program your receiver's behavior in the
event of a power failure.
Table 2-2 gives the different scenarios available and the results after power is
restored to the receiver. "Specified file" refers to the file name entered in the
Always append to file parameter.
1
Receiver data
logged to file
specified.
2
Receiver data
logged to
default file.
3
File
specified;
receiver data
logging not
started.
4
No file
specified;
receiver data
logging off.
Also, if Always is enabled, your receiver will automatically start logging data
(to a newly created or an existing file) in the following three cases:
•
•
2-20 Maxor User's Manual
Table 2-2. Data Recording Parameter Behavior
Before
Power
Failure
Off
Data logging will not
resume when power
is restored.
Data logging will not
resume when power
is restored.
No file will open
with this name.
Data logging will not
start when power is
restored.
Data logging will not
start when power is
restored.
After pressing the Power key to turn on the receiver.
After resetting the receiver (with PCView or the Reset key).
Enabled Radio Button Results
On
Receiver will resume
data logging to the
same file when
power is restored.
A new log file will
open when power is
restored and data will
log to this file.
No file will open
with this name.
Data logging will not
start when power is
restored.
Data logging will not
start when power is
restored.
Always
Receiver will resume
data logging to the
same file when
power is restored.
A new log file will
open when power is
restored and data will
log to this file.
A log file with this
name will open and
data logging will
start after power is
restored.
A log file with a
default name will
open and data
logging will start
after power is
restored.
www.javad.com