Initiate A Card Halt; Restore A Previously Halted Card - Cisco ASR 5500 Installation Manual
Hide thumbs
Also See for ASR 5500:
- System administration manual (430 pages) ,
- Administration manual (410 pages) ,
- Installation manual (192 pages)
Table of Contents
Advertisement
Initiate a Card Halt
Initiate a Card Halt
Important
Do not initiate a card halt for an active FSC if there are less than two active FSCs in the system. The system
returns an error message if there are less than two active FSCs. There are similar restrictions when executing
the card reboot or card upgrade commands on active FSCs. Refer to the Command Line Interface Reference
for detailed information.
Follow the instructions below to manually initiate a card halt. These instructions assume you are at the root
prompt for the Exec mode.
Step 1
Initiate a manual card migration by entering the following command:
[local]host_name#
slot# is the chassis slot number in which the card to be halted is installed. It can be any integer from 1 through 4, and 7
through 18. You will receive the following prompt:
Are You Sure? [Yes|No]:
Step 2
Press Y to initiate the halt operation.
Step 3
Verify that the migration was successful by entering the show card table command at the Exec mode prompt.
Check the entry in the Oper State column next to the card that was just halted. Its state should be Offline. If the card was
in active mode prior to the execution of this command, the state of the redundant component associated with it should
now be Active.
Restore a Previously Halted Card
Follow the instructions below to restore a card that was previously halted. These instructions assume you are
at the root prompt for the Exec mode.
Step 1
Reboot the card to be restored by entering the following command.
[local]host_name#
You will receive the following prompt:
Are You Sure? [Yes|No]:
Step 2
Press Y to start the reboot of the card.
Step 3
Verify that the migration was successful by entering the show card table command at the prompt.
Check the entry in the Oper State column next to the card that was just restored. Its state should be the state of that it was
in before it was halted.
Troubleshooting
22
card halt
slot#
card reboot
-force
slot#
Troubleshooting
Advertisement
Table of Contents
