Add Or Edit An Rip Route; Add Or Edit An Ospf Route - Cisco OL-4015-08 User Manual

Chapter 17 Routing

Add or Edit an RIP Route

RIP Version
IP Network List
Available Interface List
Make Interface Passive

Add or Edit an OSPF Route

OSPF Process ID
OL-4015-08
Use this window to add or edit a Routing Internet Protocol (RIP) route.
The values are RIP version 1, RIP version 2, and Default. Select the version
supported by the Cisco IOS image that the router is running. When you select
version 1, the router sends version 1 RIP packets and can receive version 1
packets. When you select version 2, the router sends version 2 RIP packets and
can receive version 2 packets. When you select Default, the router sends version
1 packets, and can receive both version 1 and version 2 RIP packets.
Enter the networks on which you want to enable RIP. Click Add to add a network.
Click Delete to delete a network from the list.
The available interfaces are shown in this list.
Check the box next to the interface if you do not want it to send updates to its
neighbor. The interface will still receive routing updates, however.
Use this window to add or edit an Open Shortest Path First (OSPF) route.
This field is editable when OSPF is first enabled; it is disabled once OSPF routing
has been enabled. The process ID identifies the router's OSPF routing process to
other routers.
Cisco Router and Security Device Manager Version 2.2 User's Guide
Add or Edit an RIP Route
17-5