Cisco OL-4015-08 User Manual page 380

Add or Edit an OSPF Route
IP Network List
Note
Available Interface List
Make Interface Passive
Add
Edit
Cisco Router and Security Device Manager Version 2.2 User's Guide
17-6
Enter the networks that you want to create routes to. Click Add to add a network.
Click Delete to delete a network from the list.
Network
The address of the destination network for this route. For more information, refer
to Available Interface
Mask
The subnet mask used on that network.
Area
The OSPF area number for that network. Each router in a particular OSPF area
maintains a topological database for that area.
If SDM detects previously configured OSPF routing that includes "area"
commands, then the IP Network List table will be read-only and cannot be edited.
The available interfaces are shown in this list.
Check the box next to the interface if you do not want it to send updates to its
neighbor. The interface will still receive routing updates, however.
Click Add to provide an IP address, network mask, and area number in the IP
address window.
Click Edit to edit the IP address, network mask, or area number in the IP address
window.
Configurations.
Chapter 17 Routing
OL-4015-08