Association - Cisco OL-4015-08 User Manual

Delete Connection
To view the associations that the connection has:
To delete the connection and all associations:
To manually delete the association:
Cisco Router and Security Device Manager Version 2.2 User's Guide
3-20
Click View Details.
Click Automatically delete all associations, and then click OK to cause SDM to
delete the connection and all of the associations.
To manually delete the associations, click View Details to see a list of the
associations that this connection has. Make note of the associations, then select I
will delete the associations later, and then click OK. You must then delete the
associations that the connection has, following the instructions in following list.
The possible associations, and the instructions for deleting them, are:
Default Static Route—The interface is configured as the forwarding interface
•
for a default static route. To delete the static route with which this interface
is associated, click Configure; then click Routing. Click the static route in
the Static Routing table, and click Delete.
Port Address Translation—PAT is configured, using the interface on which
•
this connection was created. To delete the PAT association, click Configure;
then click NAT. Click the rule associated with this connection, and click
Delete.
NAT—The interface is designated as either a NAT inside or NAT outside
•
interface. To delete the NAT association, click Configure; then click
Interfaces and Connections. Click the connection in the Interface List, then
click Edit. Click the NAT tab, then from the NAT pulldown, choose None.
ACL—An ACL is applied to the interface on which the connection was
•
created. To delete the ACL, click Configure; then click Interfaces and
Connections. Click the connection in the Interface List; then click Edit.
Click the Association tab, then in the Access Rule group, click the ... button
next to both the Inbound and Outbound fields, and click None.
Inspect—An inspection rule is applied to the interface on which the
•
connection was created. To delete the inspection rule, click Configure; then
click Interfaces and Connections. Click the connection in the Interface List,
then click Edit. Click the Association tab; then in the Inspection Rule group,
in both the Inbound and Outbound fields, choose None.
Chapter 3 Create Connection Wizards
OL-4015-08