Cisco OL-4015-08 User Manual page 457

Chapter 21 Quality of Service
Interface—IP/Mask—Slot/Port—Description
View Interval
Start Monitoring
Select QoS Parameters for Monitoring
OL-4015-08
Bandwidth utilization is shown in Kbps.
Total incoming and outgoing bytes for each traffic type
•
Incoming and outgoing bytes for each class defined under the traffic type
–
Incoming and outgoing bytes for each protocol for each class
–
If the value is more than 1,000,000, then the graph may show the bytes as a
multiple of 10^6. If the value is more than 1,000,000,000, then the graph may
show the bytes as a multiple of 10^9.
Packets dropped statistics for each traffic type
•
This area lists the interfaces with associated QoS policies, their IP addresses and
subnet masks, slot/port information if applicable, and available descriptions.
Select the interface that you want to monitor from this list.
Select the interval at which statistics should be gathered:
Now—Statistics are gathered when you click Start Monitoring.
•
Every 1 minute—Statistics are gathered when you click Start Monitoring,
•
and refreshed at 1-minute intervals.
Every 5 minutes—Statistics are gathered when you click Start Monitoring,
•
and refreshed at 5-minute intervals.
Every 1 hour—Statistics are gathered when you click Start Monitoring, and
•
refreshed at 1-hour intervals.
Click to start monitoring QoS statistics.
Select the traffic direction and type of statistics you want to monitor.
Direction
Click either Input or Output.
Cisco Router and Security Device Manager Version 2.2 User's Guide
QoS Status
21-19