Vpn Connection Information - Cisco OL-4015-08 User Manual

Create Site to Site VPN

VPN Connection Information

Select the interface for This VPN Connection
Peer Identity
Authentication
Cisco Router and Security Device Manager Version 2.2 User's Guide
8-38
Use this window to identify the
will terminate the VPN
interface to use, and to enter the pre-shared key that both routers will use to
authenticate each other.
Select the interface on this router that connects to the remote site.The router you
are configuring is represented as the Local router in the Use Case Scenario
diagram.
Enter the IP address of the remote IP Security (IPSec) peer that will terminate the
VPN tunnel you are configuring. The remote IPSec peer might be another router,
a VPN concentrator, or any other gateway device that supports IPSec.
Peer(s) with dynamic IP addresses
Select this option if the peers the router connects to use a dynamically-assigned
IP addresses.
Peer with static IP address
Select this option if the peer the router connects to uses a fixed IP address.
Enter the IP Address of the remote peer
(Enabled when Peer with static IP address is selected). Enter the IP address of the
remote peer.
Click this button if the VPN peers use a pre-shared key to
connections from each other. This key must be the same on each side of the VPN
connection.
IP address or host name of the remote site that
tunnel that you are configuring, to specify the router
Chapter 8 Site-to-Site VPN
authenticate
OL-4015-08