Add Or Edit Easy Vpn Remote: Authentication Information - Cisco OL-4015-08 User Manual

Edit Easy VPN Remote

Add or Edit Easy VPN Remote: Authentication Information

Device Authentication
User Authentication (XAuth)
Cisco Router and Security Device Manager Version 2.2 User's Guide
9-94
This window appears if the Cisco IOS image on your router supports Easy VPN
Client Phase III. If the image supports Easy VPN Client Phase II, a different
window appears.
Use this window to enter the information required for the router to be
authenticaticated by the Easy VPN server or concentrator.
Group Name
Enter the IPSec group name. The group name must match the group name defined
on the VPN concentrator or server. Obtain this information from your network
administrator.
Current Key
This field displays asterisks (*) if there is a current IKE key value. This field is
blank if no key has been configured.
New Key
Enter a new IKE key in this field.
Confirm Key
Reenter the new key for confirmation. If the values in the New Key and Confirm
Key field are not the same, SDM prompts you to reenter the key values.
If the Easy VPN server or concentrator has been configured to use XAuth, it
requires a username and password whenever the router establishes the connection,
including when you deliver the configuration to the router, and when you
disconnect and reconnect the tunnel. Find out whether XAuth is used, and obtain
the required username and password.
If user authentication does not appear, it must be set from the router
command-line interface.
Choose one of these ways to enter the XAuth username and password:
From a PC
•
Chapter 9 Easy VPN Remote
OL-4015-08