Primary Hub - Cisco OL-4015-08 User Manual

Dynamic Multipoint VPN
Tunnel Key
Bandwidth
MTU
Tunnel Throughput Delay

Primary Hub

Public IP Address
Cisco Router and Security Device Manager Version 2.2 User's Guide
11-6
Enter the key to use for this tunnel. This key should be the same for all mGRE
tunnels in the network.
SDM Default: 100000
Enter the intended bandwidth, in kilobytes per second (kbps). Default bandwidth
values are set during startup; the bandwidth values can be displayed using the
show interfaces EXEC command. 1000 is a typical bandwidth setting in DMVPN
configurations.
SDM Default: 1000
Enter the largest amount of data, in bytes, that should be allowed in a packet
travelling through the tunnel.
SDM Default: 1400
Set a delay value for an interface, in tens of microseconds.
SDM Default: 1000
If the router you are configuring is the backup
need to identify the primary hub by providing its public and private IP addresses.
Enter the IP address of the interface on the primary hub that is used for this tunnel.
This should be a static IP address. Obtain this information from the hub
administrator.
Chapter 11
hub in the DMVPN network, you
DMVPN
OL-4015-08