Ethernet Configuration - Cisco OL-4015-08 User Manual

Ethernet Configuration

What Do You Want to Do?
If you want to:
Configure or edit a LAN interface or
LAN switch port.
Reconfigure the IP address, mask, or
DHCP properties of an interface that
has already been configured.
Perform specific LAN-related
configurations for items such as DHCP
servers or maximum transmission
unit (MTU) settings.
Find out how to perform related
configuration tasks.
Ethernet Configuration
Cisco Router and Security Device Manager Version 2.2 User's Guide
2-2
Do this:
Select the LAN interface or switch port in the list, and click
Configure. If the interface has not been configured, or if you
select a switch port, SDM will take you through a LAN
wizard which you can use to configure the interface. If the
interface has already been configured and if it is not a switch
port, clicking Configure displays an Edit window in which
you can make change to the LAN configuration.
Select an interface with an IP address, and click Configure.
Click Interfaces and Connections in the SDM category bar,
click the Edit Interfaces and Connections tab and perform
the configuration changes.
See one of the following procedures:
•
•
•
•
•
You can return to this screen as often as necessary to configure additional LAN
interfaces.
The wizard guides you through the configuration of an Ethernet interface on the
LAN. You must provide the following information:
An IP address and subnet mask for the Ethernet interface
•
How Do I Configure a Static Route?
How Do I View Activity on My LAN Interface?
How Do I Enable or Disable an Interface?
How Do I View the IOS Commands I Am Sending to the
Router?
How Do I Launch the Wireless Application from SDM?
Chapter 2 LAN Wizard
OL-4015-08