Table of Contents
Advertisement
Chapter 7: Cabling AT-XEM2 Line Card Ports
172
Figure 98. Installing an 100Gbps QSFP28 Transceiver in the AT-XEM2-
Note
If you are ready to attach the fiber optic cable to the transceiver,
continue with the next step. Otherwise, repeat steps 1 to 4 to install
additional transceivers.
5. If the fiber optic connector on the transceiver has a dust cover, remove
the cover.
6. Connect the fiber optic cable to the connector on the transceiver. The
cable is keyed such that it can connect to the transceiver only one
way.
7. Repeat this procedure to install additional transceivers.
1CQ Line Card
Advertisement
Table of Contents
