Basic Key Operations; Changing The Output Function (Continuous Output/Sequence/Simulation); Item Selection; Figure 3-6 The Root Menu - NF DP015S Instruction Manual

3.3

Basic Key Operations

3.3.1 Changing the Output Function
(Continuous Output/Sequence/Simulation)
To change the Continuous output/Sequence/Simulation function, press the MENU key. This
operation displays the root menu shown in Figure 3–6.
Five icons are available in the root menu. The cursor location is informed by the highlighted icon. The
description of the icon at the cursor location is displayed in the box located at the bottom of the screen.
Move the cursor to the function you want to select by using arrow keys or the jog. Each icon in
upper line represents the Continuous output function, Sequence function, and Simulation function
from the left. When you press the ENTER key, the screen for the selected function is displayed. You
cannot change the function in the output on state. However, you can move to the Memory function
screen or System function screen.

3.3.2 Item Selection

You can move the cursor (highlighted icon) by using arrow keys or the jog. However, some items
cannot be selected depending on your model or system. These items are skipped when moving the
cursor. If you press the ENTER key, the item under the cursor is selected and run. If the item is a
menu, the menu screen, window, or selection box is displayed. If you press the CANCEL key, the
menu in the upper hierarchy is displayed without selection or execution of that item.
 Selection box
If the menu has numbers before its menu items as shown in Figure 3–7 (selection box ), pressing the
corresponding number on the numeric keypad also selects and runs the item. You can also move the
cursor by using the shuttle.
If you select an item with
displayed. In addition to the ENTER key, you can also use → arrow key to open the selection box of
that menu.
DP Series

Figure 3-6 The Root Menu

on the right, the selection box in the lower hierarchy menu is
3.3 Basic Key Operations
41