2. Preparation before Use
About power input terminal
Screw
About power input cable
The power input cable supplied with this product varies in diameter depending on the rated output as
shown in Table 2-5. A crimp-type terminal is attached to each cable on the end which is to be
connected to the input terminal of this product.
On the supplied power input cable, the end which is to be connected to the distribution board
has no terminal attached. Use a crimp-type terminal appropriate for the terminal screw
diameter of the distribution board to connect the cable firmly.
The supplied power input cable is dedicated only to this product. Do not use it with any other
product.
When you use a power input cable other than the one supplied with the product, select a cable
which has an appropriate diameter in consideration of the safety standards and consumption
current. Use a protective grounding conductor of which diameter is the same or greater than
the power input cable.
Table 2-5 Maximum Input Power/Current and Power Input Cable
Maximum
Rated
Input
output
Power
1.5 kVA
2.25 kVA
3 kVA
4.50 kVA
4.5 kVA
6.75 kVA
6 kVA
9.00 kVA
7.5 kVA
11.25 kVA
9 kVA
13.50 kVA
10.5 kVA
15.75 kVA
12 kVA
18.00 kVA
Note: The model of which rated output is 6 kVA or less contains either a power cable for both 100 V and 200 V
series input or a power cable only for 200 V series input, depending on the destination of shipment. The
dedicated cable only for 200 V series input must be used with power supply voltage of 170 to 230 V.
Power source connection procedure
Check the current capacity of the single-phase distribution board before wiring. The wiring must be
performed by a professional engineer.
WARNING
Before connecting this product to the power source, be sure to cut the power to the distribution
board. Otherwise, an electric shock might occur.
14
Table 2-4 Power Input Terminal
DP015, DP030,
DP045, DP060
M6
Maximum
Input Current
Power
Power
For both 100 V and 200 V series
Input
Input
(Power Input 90 V or More)
90 V
170 V
25 A
13 A
50 A
26 A
40 A
53 A
66 A
75 A
79 A
93 A
106 A
Supplied power input cable
AWG10
2
(5.5 mm
approx.)
AWG6
2
(14 mm
approx.)
AWG4
2
approx.)
(22 mm
AWG2
2
(38 mm
approx.)
PROGRAMMABLE AC POWER SOURCE
DP075, DP090,
DP105, DP120
M8
Only for 200 V Series
(Power Input 170 V or More)
AWG14
2
(2.1 mm
approx.)
AWG10
2
(5.5 mm
approx.)
AWG6
2
(14 mm
approx.)