Cautions During Moving And Transportation - NF DP015S Instruction Manual

 Other installation location conditions
 Use the product indoors, at altitude up to 2000 m.
 Use the product where the temperature is 0 to +50 degrees Celsius, and the humidity is 5 to
85%RH (the absolute humidity should be 1 to 25 g/m
some specifications, the temperature range limit is more strict.
 Do not install the product in the following places:
 Place exposed to inflammable gas
→This may pose a risk of explosion. Never install and use the product in such a place.
 Outdoors, place exposed to direct sunlight, or place near fire or heat source
→This may reduce the performance, or cause failure.
 Place exposed to corrosive gas or water, or humid place
→This may cause corrode or failure.
 Place near electromagnetic field source, high-voltage equipment, or power line
→This may cause malfunction.
 Place of frequent vibration
→This may cause malfunction or failure.
 Dusty place
→This may cause failure. Especially do not install the product in a place with conductive
dust.
2.3

Cautions during Moving and Transportation

Follow the instructions below when moving or transporting this product.
 Remove all wirings connected to this product.
WARNING
 Before removing the wiring, be sure to turn off this product to cut the power from the
distribution board. Otherwise, an electric shock might occur.
 Check before movement and transportation
 Check the weight before moving the product (Table 2-3).
 If you transport this product, consult with the seller (NF Corporation or our agent) from whom
you purchased the product.
 Moving with casters
The casters attached to this product is intended for use to move the product on a horizontal surface.
To move the product on a sloped or uneven surface, a licensed personnel should move it by
operating a lifting machine or crane instead of the casters.
 As this product is heavy, whenever it is moved, at least two people are required to move it.
 Move the Adjuster Foot up enough from the floor by using a spanner (19 mm diameter). You
can move the Adjuster Foot up by turning it counterclockwise as viewed from above.
DP Series

2.3 Cautions during Moving and Transportation

3
, without condensation). However, on
11