Cautions During Moving And Transportation - NF DP Series Instruction Manual

2. Preparation before Use
2.3

Cautions during Moving and Transportation

Follow the instructions below when moving or transporting this product.
 Remove all wirings connected to this product.
WARNING
 Before removing the wiring, be sure to turn off this product to cut the power from the
distribution board. Otherwise, an electric shock might occur.
 Check before movement and transportation
 Check the weight before moving the product (Table 2-4, Table 2-5).
 Moving with casters
The casters attached to this product are intended for use to move the product on a horizontal surface.
To move the product on a sloped or uneven surface, a licensed personnel should move it by
operating a lifting machine or crane instead of the casters.
 As this product is heavy, whenever it is moved, at least two people are required to move it.
 Move the Adjuster Foot up enough from the floor by using an open-end wrench (19 mm width).
You can move the Adjuster Foot up by turning it counterclockwise as viewed from above.
WARNING
 Do not use the casters to move this product on a sloped surface. This product may move
automatically due to its own weight, and cause physical injury.
 Do not use the casters to move this product on an uneven or irregular surface. This product may
fall down, and cause physical injury.
16
Adjuster Foot
Up
Down
PROGRAMMABLE AC POWER SOURCE