Set The Output Phase Mode (Multi-Phase Model Only); Power On - NF DP015S Instruction Manual

3. Basic Operation

3.2.2 Set the Output Phase Mode (Multi-phase model Only)

 Operation procedure
Switch the phase mode setting switch in the power off state depending on the output phase mode.
CAUTION
 Ensure that the power is off when you switch the phase mode setting switch. If the power is
on when you switch the phase mode setting switch, the output phase mode will not be
switched. Also, this operation does not affect the behaviors of the product. If you move the
phase mode setting switch by mistake in the power on state, be sure to move it back to the
original position. Otherwise the product starts up in unexpected output phase mode when at
power-on next time.

3.2.3 Power On

Press "On" side of the power switch. If you configured a polyphase system, all cabinets need to be
turned on within 20 seconds while the order does not matter.
38
1φ2W
1φ3W
POWER
スイッチをスライドさせて設定する。 Set the switch by sliding it.
3φ4W
OFF ON
PROGRAMMABLE AC POWER SOURCE